Volkswagen Golf Service & Repair Manual: Renewing front bonded rubber bush for lower suspension link
| Special tools and workshop equipment required |
| – |
Remove lower suspension link
→ Chapter. |
| Pressing out bonded rubber bush |
|
|
|
| – |
Press out bonded rubber bush as illustrated. |
| 2 - |
Tube -T10219/1- (the cut-out must face the suspension link) |
| 3 - |
Thrust plate -VW 402- |
| Pressing in bonded rubber bush |
|
|
|
| – |
Align bonded rubber bushes -1-
to suspension link -2-. |
| The grooves -3- must face
towards suspension link -2- as
shown in illustration. |
| – |
Moisten outer surface of bonded rubber bush with assembly
oil -G 294 421 A1-. |
|
|
|
| – |
Press in bonded rubber bush as illustrated. |
| 3 - |
Tube -T10219/1- (the cut-out must face the suspension link) |
| 4 - |
Thrust plate -VW 402- |
 Note
| At start of pressing-in process, bonded rubber bush is
temporarily slanted. During further procedure, it then
straightens. It does not have to be pushed further. |
|
|
|
| – |
Press in bonded rubber bush until core of bush
-1- and hole in suspension link
-2- are flush. |
|
|
|
| – |
Press bush back slightly in the suspension link. |
| 3 - |
Thrust plate -VW 402- |
|
|
|
| The dimensions -a- and
-b- must be the same. |
| – |
Install lower suspension link
→ Chapter. |
|
|
|
Special tools and workshop equipment required
Ball joint puller -3287 A-
Angle wrench -V.A.G 1756-
Ring spanner insert -V.A.G ...
Special tools and workshop equipment required
Tube for wheel bearing -3345-
Assembly tool -3348-
Thrust plate -VW 401-
...
© 2016-2024 Copyright www.vwgolf.org
Removing and installing swivel joint
Renewing rear bonded rubber bush for lower suspension link