Volkswagen Golf Service & Repair Manual: Renewing bulb for glove compartment light -W6-
Note
If an LED glove compartment light -W6- is faulty, the entire
light must be renewed. |
– |
Remove glove compartment light -W6-
→ Chapter. |
|
|
|
– |
If necessary, lever off heat shield
-2- on both sides at arrows -A-. |
– |
Remove heat shield -2- from
glove compartment light -W6--1-. |
|
|
|
– |
Pull bulb -1- out of bulb
holder -2- on reverse side of glove
compartment light. |
Installation is carried out in the reverse sequence. |
|
|
|
Removing
–
Turn light switch to “0” position.
–
Press in loc ...
Removing
–
Using a flat screwdriver, press in locking lug
-1- at point indicated by arrow
- ...
Other materials:
Adjusting wiper arms
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Note
If it is necessary for the wiper motor to run during the
working procedure, ...
Removing and installing handle for seat height adjustment
Note
The handle for seat height adjustment can be renewed with
front seat installed.
Removing
Note
Remove handle for seat height adjustment as
described. Do not kno ...
Continuation of checking pressures
Where vehicles have a restrictor and reservoir, check these
(with internally regulated air conditioning system compressor)
→ Chapter.
Where vehicles have an expansion valve and receiver, check
these (with internally regul ...
© 2016-2024 Copyright www.vwgolf.org