VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing tyres, run-flat tyres, ultra-high-performance tyres

Only trained personnel may perform any assembly work on run-flat tyres and ultra-high-performance tyres.
If fitted, check tyre pressure sensor using vehicle diagnostic tester, and renew it as necessary.
  Note
The tyre pressure sensor must not come into contact with water or be blown upon with compressed air when the wheel rim is cleaned.
If bonded wheel trims are fitted, treat them with great care. The surface is susceptible to scratches.
If the wheel trim is damaged, renew wheel rim.
   
–  Turn wheel, until tyre valve or tyre pressure sensor are positioned at least at 30° ahead of assembly head.
–  Insert depressor -3- opposite to assembly head -1- on wheel rim.
–  Using assembly lever, lever upper tyre bead over assembly finger.
–  Remove assembly lever.
 

Removing tyres, run-flat tyres, ultra-high-performance tyres

–  Run tyre fitting unit clockwise until upper tyre bead is fitted completely over wheel rim flange.
This action will push the depressor -1- up against the assembly head. This allows it to be removed easily.
 

Removing tyres, run-flat tyres, ultra-high-performance tyres

–  Turn wheel, until tyre valve or tyre pressure sensor are positioned at least at 30° ahead of assembly head.
–  Now lever tyre bead over assembly finger on assembly head using assembly lever -3-.
–  Using assembly lever, lever lower tyre bead over assembly finger.
–  Insert plastic assembly lever -4-.
–  Remove assembly lever -3-.
 

Removing tyres, run-flat tyres, ultra-high-performance tyres

–  Using plastic assembly lever -1- and working from outside, hold bead over wheel rim flange, and run tyre fitting unit clockwise until tyre is completely removed from wheel rim.
  Note
Check that the tyre pressure sensor is not loose or damaged. If the screwed connection is loose, replace the union nut, the valve core, the seal, the sealing washer and the valve cap with new parts from the repair set → Electronic Parts Catalogue “ETKA”.
Remove tyre pressure sensor if damaged → Chapter.
 

Removing tyres, run-flat tyres, ultra-high-performance tyres

Removing tyres, wheels without and with tyre pressure monitoring
If fitted, check tyre pressure sensor using vehicle diagnostic tester, and renew it as necessary.   Note The tyre pressure s ...

Ensuring proper assembly temperature for tyres
  Caution Risk of damage to tyres due to excessive heat. Never heat tyres with a radiator o ...

Other materials:

Removing and installing cap
Special tools and workshop equipment required     Removing   Assembly tool -T10389 –  Remove plugs -3-. –  Insert ass ...

Pneumatic brush grinder set -VAS 6446
Designation: Pneumatic brush grinder set -VAS 6446- Product description: The pneumatic brush grinder set -VAS 6446- serves as a surface treatment tool. Suitable for removal o ...

Removing and installing glow plug with flame monitoring -Q8
Removing –  Dismantling and assembling auxiliary heater → Chapter.     –  Pull out retaining spring -1- in direction of -arrow-. ...

© 2016-2024 Copyright www.vwgolf.org