Volkswagen Golf Service & Repair Manual: Removing broken rear window
| – |
Protect body and interior from glass splinters. |
| – |
Remove pieces of glass up to adhesive sealing material. |
| – |
Pull off connections for rear window heating and aerial. |
|
|
| – |
Cover flange -2- all round with
textile-reinforced adhesive tape. |
| – |
Cut through adhesive seal (with glass remains) in window
cut-out using electric cutter -V.A.G 1561 A- and U-shaped blade
-V.A.G 1561-. |
WARNING
| Always wear safety goggles and leather gloves. |
|
|
|
|
Note
The removal of a bonded window is described using the
Removal kit for flush bonded windows -V.A.G 1474 A-.
...
Other materials:
Refrigerant R134a
Air conditioners in vehicles use the evaporation and
condensation process. The system contains a liquid with a low
boiling point, called the refrigerant.
The refrigerant used is tetrafluoroethane R134a, which boils
at -26.5°C with vapou ...
Removing and installing seat trim on sill side, standard seat
Note
Removal and installation are described for the left vehicle
side. Follow same instructions for the right side as
appropriate.
Special tools and workshop equipment
required
...
Introduction
This chapter contains information on the following subjects:
→ Centre cover
→ Wheel cover
→ Wheel bolt caps
Additional information and warnings:
Cleaning and caring for the vehicle exterior
Vehicle toolkit
Changing a wheel
Breakdown set
WARN ...
© 2016-2026 Copyright www.vwgolf.org
Removing and installing rear window
Side windows