Volkswagen Golf Service & Repair Manual: Removing automatic distance control unit from and installing on retaining
plate, variant 2
Note
If the automatic distance control unit -J428- is renewed,
start the respective function → Vehicle
diagnostic tester. |
Special tools and workshop equipment
required |
|
|
|
Torque wrench -V.A.G 1331- |
|
|
|
– |
Remove adaptive cruise control unit -J428- with retaining
plate -3-. |
– |
Disconnect electrical connector -2-. |
Install in the reverse order of removal, observing the
following: |
– |
Calibrate adaptive cruise control
→ Chapter. |
→ Chapter „Overview of fitting locations – adaptive cruise
control, variant 2“ |
|
|
|
Removing:
→ Anchor
Installing:
→ Anchor
Adjusting adjustment screws:
→ Anchor
...
Special tools and workshop equipment
required
Calliper square -VAS 6335-
Removing
–
...
Other materials:
Checking charge air system for leaks
Special tools and workshop equipment
required
Charge air system tester -V.A.G 1687-
Procedure
–
Relea ...
Diagonal washout
Diagonal washout on a tyre
Diagonal washout runs at an angle of approx. 45° to the
direction of rotation.
It usually occurs at one point only, but can also occur at
several points around the circumference of the tyre.
...
Assembly overview - toothed belt, engine codes CPTA, CHPA, CZEA, CZDA
1 -
Toothed belt
Before removing, mark direction of rotation with chalk or
felt-tipped marker pen.
Check for wear
Removing
→ Chapter
Installing (adjusting valve timing), CPTA, CZEA
& ...
© 2016-2024 Copyright www.vwgolf.org