Volkswagen Golf Service & Repair Manual: Removing and installing wind deflector
| Special tools and workshop equipment
required |
|
|
|
|
|
|
Torque wrench -V.A.G 1783- |
| – |
Open glass panel completely. |
| – |
Press wind deflector net -2- downwards
-arrows a- to remove tension from it and
hold it down. |
| – |
Pull welting -3- out of assembly frame
-arrows b-. |
| – |
Remove bolts -4- on left and right. |
| – |
Pull wind deflector off assembly frame -arrow
c-. |
| – |
Push wind deflector into assembly frame. |
| – |
Tighten bolts -4- on left and right. |
| – |
Press wind deflector net -2- downwards
-arrows a- to remove tension from it and
hold it down. |
| – |
Press welting -3- into assembly frame. |
| |
Wind deflector
→ Chapter „Assembly overview - sliding sunroof“ |
Special tools and workshop equipment
required
Double cartridge gun -VAS 5237-
...
Special tools and workshop equipment
required
Height-adjustment of glass panel
...
Other materials:
Removing and installing high-level brake light, Golf
Special tools and workshop equipment
required
Plastic wedge -T10039/1-
Removing:
–
Switch off ignition and all electrical loads, and pull out
...
Removing and installing floor covering
Removing
–
Remove front seats
→ Chapter.
–
Remove rear bench seat
→ Chapter.
–
Remove sill panel mouldings
→ Chapter ...
Side airbags
Fig. 73 On the left-hand side of the vehicle:
deployment zones of side airbags (variant A). On the side of the front seat: location
and deployment range of the side airbag (variant B)
First read and observe the introductory information
and safety warnings The side airbags are located in th ...
© 2016-2024 Copyright www.vwgolf.org
Removing and installing sliding sunroof frame
Adjusting glass panel