Volkswagen Golf Service & Repair Manual: Removing and installing wheel bearing unit, multi-link suspension,
four-wheel drive
Special tools and workshop equipment
required |
|
|
|
Torque wrench -V.A.G 1332- |
|
|
|
Torque wrench -V.A.G 1410- |
– |
Loosen outer drive shaft threaded connection
→ Chapter. |
– |
Remove coil springs
→ Chapter. |
– |
Remove drive shaft
→ Chapter |
– |
Detach brake carrier with brake caliper and tie to body with
wire
→ Brake system; Rep. gr.46. |
Note
Do not suspend brake caliper by brake hose - risk of damage. |
– |
Remove bolt for brake disc and remove brake disc. |
|
|
|
– |
Pull wheel bearing unit from wheel bearing housing. |
Caution
Avoid soiling and damage to seal when placing on a
surface/storing. |
|
|
|
|
Wheel bearing -1- must always
face upwards. |
Always set wheel bearing unit on hub
-2- when placing on a surface. |
|
|
|
When picking wheel bearing up, never grasp inner side. |
Grasp only outer side of wheel bearing. |
The same procedure applies to the wheel bearing without hub. |
Install in reverse order of removal, observing the
following: |
The threaded connections of the wheel bearing housing may
only be loosened and tightened in the unladen weight position
→ Chapter. |
→ Chapter „Assembly overview - suspension, multi-link
suspension, four-wheel drive“ |
→ Chapter „Loosening and tightening threaded connections of
drive shaft“ |
→ Chapter „Torque settings for wheel bolts“ |
Bolts for heat shield, brake caliper and brake disc
→ Brake system; Rep. gr.46 |
– |
When does wheel alignment have to be checked
→ Chapter? |
|
|
|
Special tools and workshop equipment required
Fitting sleeve -3241/4-
Hub grease cap puller -VW 637/2-
Torque wrench -V.A.G 1332-
...
Special tools and workshop equipment required
Assembly tool -3301-
Assembly tool -3346-
Assembly tool -3350-
Assembly t ...
Other materials:
Removing and installing pop-up cylinder
Special tools and workshop equipment
required
Drip tray
Removing
Note
Removal and installation are described for the left side.
Removal and installation on the right side are c ...
Refrigerant machine oil
Refrigerant machine oil is miscible (approx. 20%–40%
depending on the type of air conditioner compressor and the
quantity of refrigerant) in the refrigerant. It circulates
continuously in the circuit and lubricates the moving parts.
...
Removing and installing short centre underbody cover
Note
The removal and installation procedures may have to be modified
slightly depending on engine fitted.
Removing
Unclip spreader river -2- and remove
centre underbody panels.
–
Remove bolt -3-.
Installi ...
© 2016-2024 Copyright www.vwgolf.org