VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing washer fluid reservoir

Special tools and workshop equipment required
Drip tray
  Note
Removal and installation of washer fluid reservoirs with headlight washer system are described. Removal and installation of washer fluid reservoirs without headlight washer system are carried out in the same way.
Removing
–  Remove front bumper cover → General body repairs, exterior; Rep. gr.63.
–  Remove left headlight → Chapter.
–  If necessary, remove headlight washer system pump -V11- → Chapter.
–  Place drip tray under washer fluid reservoir.
   
–  Release locking lug -3-.
  Caution
Risk of leakage.
The washer fluid reservoir is constructed in a one-piece design. The washer fluid reservoir, the filler pipe and the filler neck are not intended to be separated from each other. If they are nevertheless detached from each other, the connection could then leak.
–  Pull filler neck -1- upwards out of bracket on lock carrier -2-.
 

Removing and installing washer fluid reservoir

–  Disconnect electrical connectors -2- and -3-.
–  Release securing clips -6- in direction of arrow -A-.
–  Pull water lines -4- and -5- off windscreen washer pump.
–  Detach wiring harness from washer fluid reservoir -1-.
 

Removing and installing washer fluid reservoir

–  Unscrew nuts -1, 2 and 3-.
–  Pull washer fluid reservoir -4- off threaded pins.
Installing
Install in the reverse order of removal, observing the following:
  Note
The connections at the pump and hoses are colour-marked to prevent incorrect connection of the washer fluid lines to the windscreen and rear window washer pump -V59-. The hose fittings must be connected to the correct colour-coded pump connections during installation.
Specified torques
→ Chapter „Assembly overview - windscreen washer system“
 

Removing and installing washer fluid reservoir

Assembly overview - windscreen washer system, without headlight washer system
1 -  Right spray jet Versions with right washer jet heater element -Z21- Removing and installing → Chapter A ...

Removing and installing washer fluid reservoir, »R«
Special tools and workshop equipment required Drip tray Removing –  Remove front rig ...

Other materials:

Removing and installing left temperature flap control motor -V158-, RHD vehicles
Special tools and workshop equipment required Vehicle diagnostic tester First carry out the following work: –  Switch off all electrical consumers. –  ...

Infrared heater -VAS 6873
Designation: Infrared heater -VAS 6873- Product description: Short-wave infrared heater is used for quick drying of putty, filler, undercoat, top coat and clear coat for minor repairs. ...

Checking electromechanical parking brake, vehicles with four-wheel drive
Activate »TЬV mode«: Seat belt is fitted Rear axle on single-axle roller dynamometer Engine is switched off and ignition is switched on Auto-hold is switched o ...

© 2016-2024 Copyright www.vwgolf.org