Volkswagen Golf Service & Repair Manual: Removing and installing vacuum sender -G608
Note
The vacuum sender -G608- is only installed in selected
petrol engines. |
|
|
|
– |
Open clamp -2- and screw-type
clip -3-. |
– |
Remove air ducting hose -1-. |
|
|
|
Continuation for all models: |
– |
Disconnect connector -3- from
vacuum sender -G608--1-. |
– |
Unclip vacuum sender -G608--1-
from vacuum line -2-. |
Install in reverse order of removal, observing the
following: |
Note
Make sure to check the seal for damage before installing the
vacuum sender -G608-. |
If the seal is damaged, the vacuum sender must be renewed. |
|
|
|
Vacuum pump for brake servo, diesel
vehicles
Vacuum pump for 4-cylinder diesel engine (1.6 l, common
rail):
The vacuum p ...
The following instructions are intended to help you find the
causes of problems effectively and objectively in the event of
complaints about the brake servo or in the ...
Other materials:
Seat belt verification
Removing and installing seat occupied sensor, front passenger side -G128-
Note
The seat occupied sensor is only installed in the front
passenger seat.
Removing
WARNING
...
High-pressure sender -G65
This high-pressure sender -G65- is fitted in place of the
air conditioning system pressure switch -F129-.
When voltage is applied to the high-pressure sender, it
generates a square wave signal, or data telegram. This signal
changes when ...
Assembly overview - windscreen washer system, with headlight washer system
1 -
Right spray jet
Versions with right washer jet heater element -Z21-
Removing and installing
→ Chapter
Adjusting
→ Chapter
2 -
Left spray jet
Ver ...
© 2016-2024 Copyright www.vwgolf.org