Volkswagen Golf Service & Repair Manual: Removing and installing upper transverse link, four-wheel drive
Special tools and workshop equipment
required |
|
|
|
Torque wrench -V.A.G 1332- |
– |
Remove spring
→ Chapter. |
– |
If fitted, detach line from retainer on transverse link. |
|
|
|
– |
Unscrew nut -1- and remove
washer -2-. |
|
|
|
– |
Use felt-tip pen or similar to mark position of eccentric
bolt -3- in relation to subframe. |
– |
Unscrew nut -2- and pull out
eccentric bolt -3-. |
– |
Take out upper transverse link -1-. |
Install in reverse order of removal, observing the
following: |
The threaded connections of the suspension link may only be
loosened and tightened in the unladen weight position
→ Chapter. |
– |
Perform wheel alignment
→ Chapter. |
→ Chapter „Assembly overview - transverse link“ |
→ Chapter „Torque settings for wheel bolts“ |
|
|
|
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
Re ...
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
Re ...
Other materials:
Assembly overview - subframe
1 -
Anti-roll bar with rubber bush
Removing and installing
→ Chapter
2 -
Nut
When tightening, counterhold on multipoint socket of joint stub.
Renew after removing
...
Warning and indicator lamps
First read and observe the introductory information
and safety warnings
Lit up
Possible cause
Solution
Diesel engine is preheating before starting.
.
Brake pedal not depressed.
Press the brake pedal to ...
Checking compression
Special tools and workshop equipment
required
Spark plug socket and extension -3122 B-
Compression tester -V.A.G 1763-
...
© 2016-2024 Copyright www.vwgolf.org