Volkswagen Golf Service & Repair Manual: Removing and installing underbody heat shield
Note
The removal and installation procedures may have to be modified
slightly depending on engine fitted. |
– |
Removing centre underbody panel
→ Chapter. |
– |
Removing front tunnel cross-piece -3-
→ Chapter. |
– |
Removing rear tunnel cross-piece -2-
→ Chapter. |
– |
Removing rear exhaust system
→ Rep. gr.26. |
– |
Detach lock washers -4- (qty. 6) and
remove tunnel heat shield -1- to the back. |
Installation is carried out in reverse order. |
Note
Removal and installation are described only for the left side.
Removal and installation of the right side are similar.
Removing
–
...
Note
The removal and installation procedures may have to be modified
slightly depending on engine fitted.
Removing
–
Removing rear exh ...
Other materials:
Run-flat tyres, seal inside technology
The vehicles are equipped with self-sealing tyres as an
option.
This technology, referred to as seal inside technology, is a
system that has been developed to allow the car to continue to
be driven even if a nail or screw has penet ...
Removing and installing cover cap, for lock cylinder
Removing and installing cover cap, for
lock cylinder
Note
When removing lock cylinder cover cap, the screwdriver should
not be turned and the screwdriver should not be used as a lever.
The lock cylinder and cover cap for lock cylin ...
Service position for the front windscreen wipers
Fig. 88 Wiper blades in service position
First read and observe the introductory information
and safety warnings The windscreen wiper arms can be lifted off the windscreen
when in the service position . Carry out the following steps to move the windscreen
wipers to the service position ...
© 2016-2024 Copyright www.vwgolf.org