Note
| The removal and installation procedures may have to be modified slightly depending on engine fitted. |
| Removing |
| – | Remove centre underbody panels → Chapter. |
| – | Release retaining tab and pull out front cover -2- or -5- in direction of travel backwards off catches. |
| – | Unscrew nuts -3-. |
| – | Remove underbody panel -1- or -4-. |
| Installing |
| Install in the reverse order of removal observing the following: |
| Specified torque |
| l | Nuts → Item |
Assembly overview - underbody covers, hybrid vehicles
Removing and installing front underbody cover – e-GolfRemoving and installing ignition key battery
Removing
–
Folding out key bit -1--arrow a-.
–
Use a small screwdriver -3- to
raise the cover of battery compartment
-2--arrow b-.
  ...
Starting conditions for auxiliary heater, auxiliary heater mode
Auxiliary heater coded in Gateway
Reserve fuel level not reached
No crash shut-off
No event entries blocking start procedure
Has been put into servic ...
Removing and installing fresh air intake, RHD vehicles
Removing
–
Remove plenum chamber cover
→ General body repairs, exterior; Rep. gr.50.
–
Remove cover for fresh air intake
→ Chapter.
– ...