Volkswagen Golf Service & Repair Manual: Removing and installing tyre pressure sensor, tyre pressure sensor without
valve, customer service version
Special tools and workshop equipment
required |
|
|
|
Torque wrench -V.A.G 1410- |
Carry out the following work: |
– |
Remove tyre from wheel
→ Chapter |
|
|
|
Be sure to check which version is installed, before
performing further work. |
I - Customer service version |
In the customer service version, the tyre pressure sensor is
secured on the valve by means of a torx socket bolt
-1-. |
If the customer service version is installed, the following
work sequence applies
→ Anchor. |
In case of the production version, the tyre pressure sensor
is secured on the valve by means of a flat square head bolt
-2-. |
If the production version is installed, the following work
sequence applies
→ Anchor. |
|
|
|
– |
Unscrew bolt -arrow- for tyre
pressure sensor -1-. |
– |
Counter hold on metal valve (for example using 2 mm twist
drill). |
Caution
Before installing tyre pressure sensor, clean valve
hole. |
|
|
|
|
– |
Press tyre pressure sensor -1-
against wheel rim and tighten -arrow-. |
– |
Counter hold on metal valve (for example using 2 mm twist
drill). |
Note
After fitting, carry out a visual inspection and check that
it is securely seated. The tyre pressure sensor
-1- must be bolted such that there
is no play, and its support feet must be located in the drop
centre of the rim. |
The bolt must not be retightened to specified torque after
the installation has been completed. |
→ Chapter „Assembly overview - tyre pressure sensor, tyre
pressure sensor without valve“ |
|
|
|
Removing
–
Unscrew union nut -1-.
–
Remove tyre pressure sensor- ...
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410-
Ca ...
Other materials:
Removing and installing tail light in rear lid
Note
Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way.
If the event of a defective LED, the entire tail light needs
to be rene ...
Checking holding pressure
Special tools and workshop equipment required
Removal wedge -3409-
Pressure tester -VAS 6550-
Connector cable -VAS 6550/3-3-
Connector cable -VAS 6550/3-4-
Vehicle diagnostic tester
...
Assembly overview - centre armrest
1 -
Intermediate padding
Allocation
→ Electronic Parts Catalogue
Removing and installing
→ Chapter
2 -
Centre armrest
Removing and installing
→ Chapter
3 -
Lid
...
© 2016-2024 Copyright www.vwgolf.org