Volkswagen Golf Service & Repair Manual: Removing and installing tyre pressure sensor, Siemens tyre pressure
monitoring system
WARNING
After tyre sealant has been used, the tyre pressure
sensor of the respective wheel must be renewed. |
|
The Siemens system does not have a micro-encapsulated bolt. |
The tyre pressure sensor is secured in the wheel rim using a
union nut
→ Item. |
The metal valve body is used as an aerial. |
The connection between the metal valve body and the tyre
pressure sensor must not be interrupted. |
WARNING
When pressing the tyre pressure sensor into the well
base of the wheel rim, counterhold the metal valve from
behind with your hand. The connection between the metal
valve and the tyre pressure sensor must not be
interrupted. If the tyre pressure sensor is damaged, it
must be renewed.
|
|
– |
Press tyre pressure sensor into well base. |
– |
Secure tyre pressure sensor on metal valve using a union nut
→ Chapter. |
Specified torques
→ Anchor |
|
|
|
View of Beru system
WARNING
After tyre sealant has been used, the tyre pressure
sensor of the respe ...
Tyre sealant, use-by date
The tyre sealant in the bottle has a limited shelf-life.
The bottl ...
Other materials:
Cleaning battery clamp and battery terminal
Special tools and workshop equipment
required
VAG 1331
Note
The use of penetrating fluid, contact spray or grease etc.
is prohibited since the missing adhesion ...
Assembly overview - drive shaft, constant velocity joint VL107
1 -
Bolt
Renew after removing
Loosening and tightening
→ Chapter
Before fitting, clean the threads in the CV joint using a thread
tap.
200 Nm +180°
2 - ...
System limits
First read and observe the introductory information
and safety warnings The area monitoring system (Front Assist) has physical
and system-related limits. The driver may therefore feel that, in certain circumstances,
some Front Assist reactions occur unexpectedly or with a delay. You should t ...
© 2016-2024 Copyright www.vwgolf.org