Volkswagen Golf Service & Repair Manual: Removing and installing TV tuner, Golf
| Special tools and workshop equipment
required |
|
|
|
| Protective cap for wiring harness connector -VAS 6223/9- |
| If the control unit is replaced, select the
Replace function of the respective
control unit in Guided fault finding
→ Vehicle diagnostic tester. |
| – |
Move front seat to rearmost using longitudinal adjustment
mechanism and raise to highest position. |
| – |
Switch off ignition and all electrical consumers, and remove
ignition key. |
|
|
|
| – |
Pull out spreader rivets -2-,
slide cover -1- straight in
direction of travel and remove it. |
|
|
|
| – |
Release connector -2- on
digital TV tuner -R171--1- and
separate. |
|
|
|
| – |
Push protective cap for cable connector -VAS 6223/9--1-
onto connector of MOST bus -2-. |
|
|
|
| – |
Release connector -3- on
digital TV tuner -R171--1- and
separate. |
| – |
Swing digital TV tuner -R171--1-
out of bracket. |
| Install in the reverse order of removal. When doing this,
note the following: |
 Note
| When installing, ensure that the digital TV tuner -R171- is
seated correctly in the groove in the retainer. |
| When installing the cover, ensure that it is properly fitted
on the front edge of the retainer. |
|
|
|
1 -
Display unit for control device of front display and information
control panel -J685-
Removing and installing
→ Chapter „Removing a ...
Special tools and workshop equipment
required
Protective cap for wiring harness connector -VAS 6223/9-
...
© 2016-2026 Copyright www.vwgolf.org
Fitting locations overview - TV system
Removing and installing TV tuner, eGolf