Volkswagen Golf Service & Repair Manual: Removing and installing trim for backrest release mechanism
– |
Pull operating lever -1-
upwards -arrow A-. |
– |
Insert flat-bladed screwdriver between trim and operating
lever as shown in illustration. |
– |
Release right locking hook -arrow B-. |
|
|
|
– |
Hold operating lever -1- in
operated position and insert flat-bladed screwdriver between
trim and operating lever as shown in illustration. |
– |
Release left locking hook -arrow B-. |
|
|
|
– |
Move operating lever -1- back
to rest position. |
– |
Detach trim -2- in
-direction of arrow- by hand. If
necessary, also push on opposite side. |
Install in reverse order, but note the following: |
– |
Move operating lever slightly upwards, guide trim over
operating lever and attach rear detent in backrest release
mechanism. |
|
|
|
Removing
–
Remove backrest cover and backrest padding
→ Chapter.
...
Removing
–
Remove backrest cover and backrest padding
→ Chapter.
...
Other materials:
Assembly overview - coolant pump, thermostat
1 -
Thermostat housing
Removing and installing
→ Chapter
2 -
Thermostat
For small cooling circuit
Starts to open at approx. 105°C
Different versions. Refer to
...
Assembly overview - window regulator
1 -
Front door
2 -
Rear window regulator motor -V26/V27-
The door control unit is installed in door separated from window
regulator motor
Removing and installing
→ Chapter
3 -
Hexagon nut
...
Leaks or internal damage (e.g. noises or lack of power)
–
Drain refrigerant circuit.
–
Remove air conditioner compressor.
Note
In the event of internal damage (to air conditioner
compressor), purge with R134a refrigerant
→ ...
© 2016-2024 Copyright www.vwgolf.org