Volkswagen Golf Service & Repair Manual: Removing and installing track rod ball joint
Special tools and workshop equipment
required |
|
|
|
Ball joint puller -T10187- |
|
|
|
Torque wrench -V.A.G 1332- |
|
|
|
– |
Mark position of track rod ball joint on track rod. |
– |
Loosen nut -2- on track rod
ball joint but do not remove completely. |
Caution
Leave nut screwed on a few turns to protect thread
on pin. |
|
– |
Push track rod off wheel bearing housing and remove nut. |
1 - |
Ball joint puller -T10187- |
– |
Unscrew track rod ball joint from track rod. |
Install in reverse order of removal, observing the
following: |
|
|
|
– |
Make sure that correct track rod ball joint is installed on
each side. |
I - |
Track rod ball joint on right marked with an “A” |
II - |
Track rod ball joint on left marked with a “B” |
– |
Screw track rod ball joint onto track rod as far as
previously applied mark and secure with lock nut. |
– |
Insert track rod ball joint into wheel bearing housing. |
– |
Bolt track rod ball joint with new nut. |
– |
Check wheel alignment
→ Chapter. |
→ Chapter „Assembly overview - steering rack“ |
→ Chapter „Repairing steering rack“ |
→ Chapter „Torque settings for wheel bolts“ |
|
|
|
Special tools and workshop equipment required
Torque wrench -V.A.G 1332-
Open-end insert, 38 mm -V.A.G 1923-
Ball joint puller -T10 ...
1 -
Right track rod ball joint
Marked with “A”
→ Anchor
Removing and installing
→ Chapter
...
Other materials:
Removing and installing poly V-belt, vehicles with air conditioner
compressor
Special tools and workshop equipment
required
Locking pin -T10060 A-
Removing
–
To slacken poly V ...
System limits
First read and observe the introductory information
and safety warnings The area monitoring system (Front Assist) has physical
and system-related limits. The driver may therefore feel that, in certain circumstances,
some Front Assist reactions occur unexpectedly or with a delay. You should t ...
Assembly overview - cylinder head
Note
The camshafts must not be removed individually.
In the event of repair, the camshaft housing must be renewed
completely.
Note
The illustration shows the cylinder head for en ...
© 2016-2024 Copyright www.vwgolf.org