Volkswagen Golf Service & Repair Manual: Removing and installing track rod
Special tools and workshop equipment
required |
|
|
|
Torque wrench -V.A.G 1331- |
|
|
|
Torque wrench -V.A.G 1332- |
|
|
|
– |
Unscrew bolts -arrows- for
anti-roll bar -1-. |
|
|
|
– |
Unscrew nut -1- and bolt
-3- by a few turns. |
– |
Unscrew nut -1-, and remove
bolt -4- towards rear. Push
anti-roll bar upwards while doing so. |
Install in reverse order of removal, observing the
following: |
The threaded connection of the track rod may be tightened
only when the dimension measured between the centre of wheel hub
and lower edge of wheel housing before starting the work has
been attained
→ Chapter. |
– |
Perform wheel alignment
→ Chapter. |
→ Chapter „Assembly overview - track rod“ |
→ Chapter „Assembly overview - anti-roll bar“ |
→ Chapter „Torque settings for wheel bolts“ |
|
|
|
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
Re ...
Other materials:
Tyre sizes for vehicles with four-wheel drive
The following points must be observed for vehicles with
four-wheel drive:
Only tyres of the same make, design and tread pattern may be
fitted to the front and rear axles.
Different tyre rolling circumferences ...
Wax-based underseal -D 316 000 A1
Designation:
Wax-based underseal -D 316 000 A1-
Issued 01.2008
Product description
Wax underseal -D 316 000 A1- offers excellent long-term
underbody corrosion protection.
...
Assembly overview - water deflector
Note
The right side is shown. The left side is similar.
1 -
Water deflector
Removing and installing
→ Chapter
2 -
Retaining strip
–
During removal, drill out rivet heads and cho ...
© 2016-2024 Copyright www.vwgolf.org