Volkswagen Golf Service & Repair Manual: Removing and installing throttle valve module -GX3-
Throttle valve module -GX3- consists of |
Throttle valve module -J338- |
Throttle valve drive for electronic power control -G186- |
Throttle valve drive angle sender 1 for electronic power
control -G187- |
Throttle valve drive angle sender 2 for electronic power
control -G188- |
– |
Move clear air hoses at charge air pipe. |
|
|
|
– |
Release fasteners -arrows-
using release tools -T10527- and -T10527/1-. |
|
|
|
– |
Open hose clips -arrows- and
detach air duct -1-. |
|
|
|
– |
Disconnect electrical connector -3-. |
– |
Unscrew bolts -arrows- and
remove throttle valve module -GX3--1-
with adapter -2-. |
Installation is carried out in the reverse order; note the
following: |
– |
After throttle valve control module -GX3- has been renewed,
it must be re-adapted to engine control unit -J623-. To do this,
use vehicle diagnostic tester. |
→ Chapter „Assembly overview - intake manifold“ |
|
|
|
Special tools and workshop equipment
required
Release tool -T10527-
Release tool -T10527/1-
...
Other materials:
Infrared heater -VAS 6879
Designation:
Infrared heater -VAS 6879-
Product description:
The infrared heater is used to dry putty, filler, base coat,
top coat and clear coat on vertical or horizontal surfaces.
...
Removing and installing glove compartment light switch -E26-
Note
The removal and installation procedures are described for
LHD vehicles. Removal and installation for RHD vehicles are
similar.
Removing
–
Open glove compartment.
...
Locking and unlocking the vehicle with Keyless Access
Fig. 30 Keyless Access locking and starting
system: operating range
Fig. 31 Keyless Access locking and starting
system: sensor Ⓐ for locking on the inside of the door handle and sensor Ⓑ for unlocking
on the outside of the door handle
First read and observe the introductory information ...
© 2016-2024 Copyright www.vwgolf.org