Volkswagen Golf Service & Repair Manual: Removing and installing temperature sensor -G18- and overheating sensor -G189

Volkswagen Golf Service & Repair Manual / Auxiliary heater / Aux. heater/heater booster / Auxiliary heater / Removing and installing temperature sensor -G18- and overheating sensor -G189

Removing

–	Dismantling and assembling auxiliary heater → Chapter.

–	Remove bolt -1- (4 Nm) and remove retaining spring -2-.

–	Pull out temperature sensor -G18--3-and overheating sensor -G189--4- using long nose pliers.

Installing

Install in reverse order.

–	Renew seals.

–	Check sealing surfaces and clean if necessary.

–	Before inserting sensors, coat seals with coolant.

Removing and installing temperature sensor -G18- and overheating sensor -G189

–	When assembling, ensure that retaining spring is in proper position -2-.

Note

Sensors cannot be renewed separately.

Specified torque

→ Chapter „Assembly overview - auxiliary heater attachments“

Removing and installing temperature sensor -G18- and overheating sensor -G189

Removing and installing glow plug with flame monitoring -Q8

Removing – Dismantling and assembling auxiliary heater → Chapter. ...

Connector pin assignment for auxiliary heater

1 - 6-pin connector Information on pin assignment can be found in the latest current flow diagram → Current flow diagrams, Electrical fau ...

Other materials:

Connection diagram - activated charcoal filter
Note Fuel tank leak detection takes advantage of the fact that a vacuum develops naturally in the fuel system as the fuel in the tank cools. The variables temperature and pressure are necessary for fuel tank leak detection. The temperature senso ...

Removing and installing rear left vehicle level sender -G76-, multi-link suspension, four-wheel drive
Special tools and workshop equipment required Torque wrench -V.A.G 1410- Removing – Disconnect co ...

Assembly overview - valves
1 - Inlet valve Do not rework. Only lapping in is permitted. Valve dimensions → Chapter Checking valve guides → Chapter. 2 - Exhaust valve Do not re ...