Volkswagen Golf Service & Repair Manual: Removing and installing temperature flap control motor -V68-, LHD vehicles
Heater and air conditioning system with electric/manual
controls |
Special tools and workshop equipment
required |
Vehicle diagnostic tester |
– |
Equipment version with ignition lock: Remove ignition key. |
Pyrotechnic components may trigger unintentionally.Risk of
injury.Discharge any static charge accumulated in your body by briefly
touching striker plate for door.
– |
Remove footwell vent on driver side
→ Chapter. |
|
|
|
– |
Pull actuating lever -3- off
heater unit. |
Note
The upper bolt can be accessed with a commercially available
ratchet. |
– |
Unscrew bolts -arrows-. |
– |
Disconnect electrical connector -2-. |
– |
Remove temperature flap control motor -V68--1-. |
|
|
|
Installation is carried out in the reverse order. When
installing, note the following: |
Note
Check operation of flaps and hinge mechanism before fitting. |
Make sure levers and shafts are properly fitted in the
mounts. |
– |
Fit control motor -1- on air
distribution housing. Gear wheel -2-
on control motor must engage in the gear wheel
-3- on actuating lever. |
The long tooth -4- must engage
in recess -arrow- on actuating
lever. |
Note
If the gear wheels on the control motor and temperature flap
lever do not align, rotate the receptacle in the control motor. |
If the bolts cannot be fitted, the control motor is not
completely seated on the housing. |
– |
Switch on ignition, connect respective control motor to
vehicle wiring harness and select a setting on operating and
display unit to set control motor to desired position (e.g.
mid-position). Wait until control motor has moved to desired
position and switch off ignition. |
– |
Route wiring harness so that it cannot come into contact
with any moving parts (e.g. actuating arm on control motor). |
– |
Read event memory, and clear any entries displayed. Then,
perform “basic setting”vehicle diagnostic tester in “Guided
fault finding” mode. |
– |
As a final step, check operation of heater and air
conditioning system. |
→ Chapter „Assembly overview - heater and air conditioning unit“ |
|
|
|
1 -
Control motor for fresh air and air recirculation flap and air flow
flap -V425-
With potentiometer for fresh air/recirculated air and air flow flap ...
Heater and air conditioning system with electric/manual
controls
Special tools and workshop equipment
required
Veh ...
Other materials:
Checking airbag securing parts after an accident
All damaged securing parts must always be renewed. It is not
permissible to bend the components back into shape or
»make them fit«
The following components must be checked after the relevant
airbag has been triggered.
...
Securing engine on engine and gearbox support
Special tools and workshop equipment
required
Engine and gearbox support -VAS 6095-
Workshop hoist -VAS 6100-
...
Vehicle settings menu
First read and observe the introductory information
and safety warnings
Opening the Vehicle settings menu
Switch on the ignition.
If necessary, switch on the infotainment system.
Press the
infotainment
button.
Touch the function button
to open ...
© 2016-2024 Copyright www.vwgolf.org