Volkswagen Golf Service & Repair Manual: Removing and installing tank pressure sensor -G400
 Note
| The tank pressure sensor -G400- is located in the pressure
regulating valve on the activated charcoal filter
→ Chapter. |
| – |
Remove activated charcoal filter
→ Chapter. |
|
|
|
| – |
Remove hose -1- from activated
charcoal filter -2-. |
| – |
To do this, loosen clamps -arrows-. |
|
|
|
| – |
Unscrew bolts -arrows- for
pressure regulating valve -1- on
activated charcoal filter -2-. |
|
|
|
| – |
Pull pressure regulating valve -1-
in -direction of arrow- out of seal
-3- on activated charcoal filter
-2-. |
|
|
|
| Install in reverse order. In the process, note the
following: |
| – |
Make sure that seal -3- is
properly seated. |
| → Chapter „Assembly overview - activated charcoal filter system“ |
|
|
|
Special tools and workshop equipment
required
Removal wedge -3409-
...
Removing
Fitting location
→ Item:
–
Release and pull off conn ...
Other materials:
Golf GTI - from model year 2013, sales type 5G1
Note
The specified wheel and tyre combinations apply for all the
gearboxes allocated to the respective engines.
Deviations from this are specially indicated in the table.
The Golf GTI will be listed according to the sales type, not type
app ...
Programming the auxiliary heater
First read and observe the introductory information
and safety warnings Before programming, check that the date
and time set in the vehicle are correct .
The auxiliary heater can be programmed via the Auxiliary heater menu in the infotainment
system.
Opening the Auxiliary heater menu ...
Measuring axial play of camshaft
Special tools and workshop equipment
required
Universal dial gauge bracket -VW 387-
Dial gau ...
© 2016-2024 Copyright www.vwgolf.org
Removing and installing fuel gauge sender 2 -G169
Removing and installing control unit for fuel tank leak detection -J909-