|
– | Remove wheel housing liner → Chapter. |
– | Disconnect connector -2- for switch -3-. |
– | Remove bolt -3-. |
– | Slightly pull tank flap unit towards rear -arrow a- out of catches. |
– | Swing tank flap unit -1- out of the side panel -arrow b-. |
|
– | Push electrical wiring for switch into side panel, and connect it. |
– | Swing tank flap unit -1- into the side panel -arrow b-. |
– | Then, push tank flap unit completely into side panel -arrow a-. |
– | Tighten bolt. |
l | Check function of release components. |
Specified torques |
Safety precautions during road tests in which test and measuring equipment
is used
Risk of injury due to unsecured test and measuring equipment
If a front passenger airbag is triggered during an accident,
unsecured test and measuring equipment can become dangerous projectiles.
–
Secure test and measuring equipment with seat belts on ...
Removing and installing refrigerant line between condenser and air
conditioner compressor
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331/- (5…50 Nm)
Air conditioner service station
...
Special driving situations
Fig. 170 A: vehicle in a bend B: motorbike
in front is outside the range of the radar sensor
Fig. 171 C: vehicle is changing lanes.
D: turning vehicle, stationary vehicle
First read and observe the introductory information
and safety warnings The Adaptive Cruise Control (ACC) has physica ...