|
– | Screw off tank cover. |
– | Remove bolt -3-. |
– | Slightly pull tank flap unit towards rear -arrow a- out of catches. |
– | Swing tank flap unit -1- out of the side panel -arrow b-. |
– | Guide water drainage hose -4- together with tank flap unit out of side panel. |
|
– | Insert water drainage hose -4- through opening in tank flap unit -1- and then pull it through as far as it will go. |
– | Slide water drainage hose -4- into side panel -arrow a-. |
– | Swing tank flap unit -1- into side panel -arrow b- and pull sleeve over filler neck -2-. |
– | Then, push tank flap unit completely into side panel -arrow c-. |
l | Check function of release components. |
Specified torques |
Overview of fitting locations - components not located in passenger
compartment, Golf and Golf GTE, RHD vehicles
1 -
Exhaust ventilation for passenger compartment
Checking
→ Chapter
Removing and installing
→ Chapter.
2 -
Humidity sender for air conditioning system -G260-
Check ...
Removing air conditioner compressor from and installing to bracket, Golf and
Golf Estate
Note
In vehicles with start-stop system, note abort conditions:
→ Chapter
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331- (5 ...
Removing and installing covers for auxiliary heater control unit -J364
Removing
–
Switch off electrical consumers.
–
Switch off auxiliary and supplementary heater and switch off
ignition.
–
Remove auxiliary heater
→  ...