Volkswagen Golf Service & Repair Manual: Removing and installing tail light

Note

Removal and installation are described for the left side. Removal and installation on the right side are carried out in the same way.

If the event of a defective LED, the entire tail light needs to be renewed.

Removing

–	Turn light switch to “0” position.

–	Open cover in luggage compartment side trim.

–	Unscrew securing element -1-.

–	Disconnect electrical connector.

–	Remove tail light -2- in direction of arrow -A-.

Installing

Install in the reverse order of removal, observing the following:

–	Test functionality.

Specified torques

→ Chapter „Assembly overview - tail lights in vehicle body, with bulbs“

Removing and installing tail light

Note Installation position can only be corrected on tail light cluster on body. Removal and installation are described for ...

Note Removal and installation are described for the left side. Removal and installation on the right side are carried out in the same way. ...

Removing and installing bracket for onboard supply control unit -J519-, RHD vehicles
Removing – With ignition switched off, disconnect earth cable from battery → Chapter. – Remove dash panel → General body repairs, interior; Rep. gr.70. ...

Overview of fitting locations - entry and start authorisation system, RHD vehicles
1 - Immobiliser reader coil -D2- Removing and installing → Chapter 2 - Control unit for electronic steering column lock -J764- Removing and installing → Running gear, axles, steering ...

Removing and installing control unit and hydraulic unit, RHD vehicles
Special tools and workshop equipment required Torque wrench -V.A.G 1331- Torque wrench -V.A.G 1410- Brake pedal depressor -V.A.G 1869/2- Sealing plugs, assemb ...