Volkswagen Golf Service & Repair Manual: Removing and installing swivel module position sensor -G474-/-G475-

Volkswagen Golf Service & Repair Manual / Electrical system / Lights, lamps, switches outside / Headlight / Removing and installing swivel module position sensor -G474-/-G475-

Note

Left swivel module position sensor -G474- and right swivel module position sensor -G475- are only fitted on gas discharge headlights.

The swivel module position sensor is located in the headlight housing and cannot be renewed separately in the event of a fault.

–	Removing and installing headlights → Chapter.

Removing and installing dynamic cornering light control motor-V318-/-V319-

Note

Left dynamic cornering light control motor -V318- and right dynamic cornering light control motor -V319- are only fitted on gas discharge headlights.

The dynamic cornering light control motor is located in the headlight housing and cannot be renewed separately in the event of a fault.

–	Removing and installing headlights → Chapter.

Removing and installing control motor sender for VARILIS headlight -G695-/-G696-

Note Control motor sender for left VARILIS headlight -G695- and control motor sender for right VARILIS headlight -G696- are only fitted on gas di ...

Fog lights

Assembly overview - fog lights, Golf 1 - Fog lights Different versions. Refer to → Electronic Parts Catalogue. Removing and ...

Other materials:

Welding and soldering on refrigeration systems
Before welding and brazing on vehicles (in the vicinity of the air conditioning system components), extract the refrigerant and then purge the system by blowing through with compressed air and using nitrogen. The products of decompositio ...

Balancing wheel, balancing wheel with finish balancer
Note Before working with a finish balancer, the mechanic needs to have been instructed by the manufacturer of the balancer. To balance the wheels, set the wheels of the driven axle on the sensor platforms. On front-w ...

Assembly overview - airbag control unit
1 - Airbag control unit -J234- Removing and installing → Chapter The control unit is earthed via the housing with the body 2 - Nut Nut and earth stud form the earth connection for the control unit Threads must be ...