VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing support for luggage compartment floor, saloon

Volkswagen Golf Service & Repair Manual / General body repairs, interior / Trim, noise insulation / Luggage compartment trims / Removing and installing support for luggage compartment floor, saloon

  Note
Removal and installation are described for the left vehicle side. Follow same instructions for the right side as appropriate.
Special tools and workshop equipment required
   
   

Torque wrench -V.A.G 1783
Torque wrench -V.A.G 1783

Removing
–  Fold down rear seat backrests.
–  Remove luggage compartment floor towards rear.
–  Remove bolts -2-.
–  Remove luggage compartment floor covering bracket -1-.
Installing
Installation is carried out in reverse order.
Specified torques
  → Chapter „Assembly overview - luggage compartment floor“
 

Torque wrench -V.A.G 1783

Removing and installing tie-down rings
  Note Removal and installation are described for the left vehicle side. Follow same instructions for the right side as appropriate. ...

Removing and installing support for luggage compartment floor, estate
Special tools and workshop equipment required     Removing –  Fold down rear ...

Other materials:

Removing and installing brake light switch, LHD vehicles
Removing     Vehicles with diesel engine: –  Remove air hose from air filter housing.   On »R« vehicles: ...

Removing and installing lower suspension link, vehicle with dual clutch gearbox 0D9
Special tools and workshop equipment required     Torque wrench -V.A.G 1332- Removing –  Loosen wheel bolts. –  ...

Corrosion protection for body components, add-on components and welded components
Attachments   Wings, doors, covers and flaps must be coated completely on the inside as well. One wet-in-wet spray pass is adequate for this.   Before installing, add-on parts must be sealed with cav ...

© 2016-2024 Copyright www.vwgolf.org