Volkswagen Golf Service & Repair Manual: Removing and installing sunlight penetration photosensor -G107-
Special tools and workshop equipment
required |
|
|
|
– |
Unclip sunlight penetration photosensor
-1- in direction of arrow from dash
panel. |
– |
Install in reverse order. |
|
|
|
The air quality sensor detects noxious substances in the
ambient air (primarily petrol and/or diesel fumes).
The Climatronic control unit -J255 ...
Other materials:
Removing and installing C-pillar trim, saloon
Note
Removal and installation are described for the left
vehicle side. Follow same instructions for the right side as
appropriate.
Special tools and workshop equipment
required
...
Routing and securing wiring
Mark lines prior to removal to prevent them from being
interchanged and to ensure that they are fitted in their
original positions. This applies for fuel, hydraulic and vacuum
lines as well as lines for activated charcoal filter system and
electrical wir ...
Adjusting clutch engagement
The position of the engagement bearings “K 1” and “K 2” must
only be adjusted after the following work:
Clutch has been renewed.
Engaging levers were renewed.
Small ba ...
© 2016-2024 Copyright www.vwgolf.org