|
|
Note
|
|
Removing |
– | Remove bolts -2- and remove striker -1-. |
Installing |
– | Position striker pin -1- on B-pillar -3- and tighten bolts -2-. |
– | Adjusting striker pin → Chapter |
Component | Specified torques | |
Striker pin | 20 Nm |
Removing and installing window regulator
Special tools and workshop equipment
required
Note
Removal and installation are described only for the left
window regulator. Removal and installation of the ...
Factory fitted towing attachment
If the vehicle was supplied with a factory fitted towing
attachment, everything with regards to the technical and legal
requirements has already been taken care of.
It should be noted that from the start of 1988 a
»13-pin« trailer socke ...
Removing and installing defroster flap control motor -V107- with
potentiometer -G135-, RHD vehicles
Special tools and workshop equipment
required
Vehicle diagnostic tester
First carry out the following work:
–
Switch off all electrical consumers.
–
...