Volkswagen Golf Service & Repair Manual: Removing and installing striker pin
Special tools and workshop equipment
required |
|
|
|
|
|
Torque wrench -V.A.G 1331- |
Note
Removal and installation are described only for the right
door striker pin. The right side is similar. |
|
|
Socket -3410-
|
Note
A bent striker pin (square U-shape) must be installed. |
|
|
Remove bolts -2- and remove striker
-1- |
– |
Position striker pin -1- on
B-pillar -3- with the U-shape
facing inwards. Tighten bolts -2-. |
– |
Adjusting striker pin
→ Chapter |
|
|
|
Component |
Specified torques |
Striker pin |
20 Nm |
Special tools and workshop equipment
required
Note
Removal and installation are described only ...
Removing and installing cover cap, for
lock cylinder
Note
When removing lock cylinder cover cap, the screwdriver should
not be turned a ...
Other materials:
Removing and installing air recirculation flap control motor -V113-, LHD
vehicles
Heater and air conditioning system with electric/manual
controls
Special tools and workshop equipment
required
Vehicle diagnostic tester
Note
The control motor has end stops wi ...
Switching TCS or TCS with ESC on and off
Fig. 142 In the centre console: button
for switching the traction control system (TCS) or electronic stability control
(ESC) on and off manually
Fig. 143 In the centre console: button
for switching the traction control system (TCS) on and off manually (vehicles without
ESC)
First read an ...
Notes for vehicles with start-stop system
Observe the safety precautions for vehicles with a
Start/Stop system
→ Chapter.
The following abort conditions deactivate the
start-stop-function:
The Start/Stop system has been switched off via th ...
© 2016-2024 Copyright www.vwgolf.org