Volkswagen Golf Service & Repair Manual: Removing and installing striker pin
|
|
|
| Removing |
| – | Remove trim for rear lid lock → General body repairs, interior; Rep. gr.70. |
| – | Unscrew hexagon nuts -2- and remove striker pin -1- from lock carrier. |
| Installing |
| – | Mount striker pin -1- with hexagon nuts -2- onto lock carrier. |
| – | Adjusting striker pin → Chapter. |
| Specified torques |
Hexagon nut → Chapter „Assembly overview - rear lid“
Removing and installing hinges
Special tools and workshop equipment
required
Removing
Torque wre ...
Removing and installing rear lid seal
In the factory a sealant is applied to the rear lid seal, the seal is fitted
to the body flange and then rolled on.
Note
When the seal is removed, the sealant on the inside of the seal will
...
Other materials:
Removing and installing anti-roll bar
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Removing
–
Loosen wheel bolts.
–
...
Removing and installing tensioner for poly V-belt, vehicles without air
conditioner compressor
Removing
–
Remove poly V-belt from tensioner
→ Chapter „Removing and installing poly V-belt, vehicles without
air conditioner compressor“.
–
...
Removing and installing dash panel central tube
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331
Note
If electrical wires are disconnected or removed and
installe ...
