Volkswagen Golf Service & Repair Manual: Removing and installing steering column electronics control unit -J527-,
Kostal
Note
Airbag coil connector and return ring with slip ring -F138-
is integrated in steering column electronics control unit
-J527-. |
When renewing the control unit, select “Renew” function for
the respective control unit in “Guided fault finding” or “Guided
functions” mode → Vehicle
diagnostic tester. |
– |
Turn wheels to straight-ahead position – steering wheel in
straight-ahead position. |
– |
Move steering wheel to rearmost and lowest position. Use the
entire range of adjustment of the steering column for this
purpose. |
– |
Remove steering wheel
→ Running gear, axles, steering; Rep. gr.48. |
– |
Remove lower steering column trim
→ General body repairs, interior; Rep. gr.68. |
WARNING
Risk of damage to the electronic components due to
electrostatic discharge. |
Before disconnecting the electrical connector, the
mechanics must electrostatically discharge themselves by
briefly grasping hold of door striker plate or similar. |
|
|
|
|
– |
Press connector lock in direction of arrow -A-
and disconnect electrical connector -1-. |
– |
Press connector lock in direction of arrow -B-
and disconnect electrical connector -2-. |
– |
Press connector lock in direction of arrow -C-
and disconnect electrical connector -3-. |
– |
Pull out connector lock in direction of arrow
-D- and press it down. |
– |
Disconnect electrical connector -4-. |
– |
Press connector lock in direction of arrow -E-
and disconnect electrical connector -5-. |
– |
Pull out connector lock in direction of arrow
-F- and press it down. |
– |
Disconnect electrical connector -6-. |
– |
Release retaining tabs in direction of arrows
-A- and -B-. |
– |
Remove steering column electronics control unit -J527--2-
from steering column combination switch -E595-. |
Install in the reverse order of removal, observing the
following: |
|
|
|
– |
Before pushing on steering column electronics control unit
-J527--3-, ensure the following: |
The “arrows”-1- must align. |
Coil connector -2- must be
visible through window between “arrows”-4-. |
– |
All connectors must be engaged securely. |
→ Chapter „Assembly overview - steering column switch module“ |
|
|
|
Removing
–
Move steering wheel to rearmost and lowest position. Use the
entire range of adjustment of the steering column for this
...
Note
Airbag coil connector and return ring with slip ring -F138-
is integrated in steering column electronics control unit
-J527-.
...
Other materials:
Removing and installing drive shaft
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
Press tool -T10520-
...
Distinguishing features of jointless wiper blades
Distinguishing features of Bosch and Federal Mogul products.
When renewing wiper rubbers, note the make. When renewing
wiper blades, the same make must be used.
Wiper blades can be identified according to wiper arm
...
Introduction
This chapter contains information on the following subjects:
→ Petrol
→ Diesel
→ Bioethanol (Ethylalcohol)
Different engines require different fuels. The factory-fitted sticker on the
inside of the tank flap indicates the fuel type that is required for your ...
© 2016-2024 Copyright www.vwgolf.org