Volkswagen Golf Service & Repair Manual: Removing and installing starter, vehicles with double clutch gearbox (DQ200–7F)

Volkswagen Golf Service & Repair Manual / Electrical system / Starter- current supply- CC / Starter / Removing and installing starter, vehicles with double clutch gearbox (DQ200–7F)

Special tools and workshop equipment required

Torque wrench -V.A.G 1331-

Removing and installing starter, vehicles with double clutch gearbox (DQ200–7F)

Torque wrench -V.A.G 1332-

Removing

–	With ignition switched off, disconnect earth cable from battery -A- → Chapter.

Vehicles with TDI engine

–	Remove air filter housing → Rep. gr.23.

Continued for all vehicles

Removing and installing starter, vehicles with double clutch gearbox (DQ200–7F)

–	If fitted, unscrew nut -1- from upper securing bolt of starter -B-.

–	If fitted, remove earth cable -2-.

Removing and installing starter, vehicles with double clutch gearbox (DQ200–7F)

–	Disconnect electrical connector -4-.

–	Press off cap -5-.

–	Unscrew nut -6- and remove terminal 30/B+.

–	Remove bolts -1- and -2- from starter -B--3-.

–	Remove starter -B--3- upwards.

Installing

Install in the reverse order of removal, observing the following:

Specified torques

→ Chapter „Assembly overview - starter“

–	Reconnect battery -A- → Chapter.

Removing and installing starter, vehicles with double clutch gearbox (DQ200–7F)

Removing and installing starter, vehicle with manual gearbox

Special tools and workshop equipment required Torque wrench -V.A.G 1331- ...

Removing and installing starter, vehicles with double clutch gearbox (DQ250-6F)

Special tools and workshop equipment required Torque wrench -V.A.G 1331- ...

Other materials:

Removing and installing front footwell light -K268-, driver side
Removing – Using a flat screwdriver, press in locking lug -1- at point indicated by arrow -A-. – Lever out footwell light -2-. –& ...

Bleeding hydraulic system following standard procedure
Note Bleeding the hydraulic system using brake filling and bleeding equipment -VAS 5234- is described. A pre-pressure of 2 bar is required for bleeding the ABS hydraulic unit -N55-. Specia ...

Removing and installing model designation on radiator grille
Note The description applies for all emblems. Here the “GTI” emblem is shown as an example. Removing – Removing radiator grille → Chapter – ...