Volkswagen Golf Service & Repair Manual: Removing and installing spring, torsion beam axle

Volkswagen Golf Service & Repair Manual / Running gear, axles, steering / Rear suspension, drive shaft / Suspension strut, shock absorber, spring / Removing and installing spring, torsion beam axle

Special tools and workshop equipment required

Spring compressor -V.A.G 1752/1-

Removing and installing spring, torsion beam axle

Spring retainer -V.A.G 1752/3A-

Adapter -V.A.G 1752/9-, not illustrated

Removing

–	Loosen wheel bolts.

–	Raise vehicle.

–	Remove wheel.

Removing and installing spring, torsion beam axle

–	Pull out clip -1- in -direction of arrow- onto stop.

Removing and installing spring, torsion beam axle

–	Insert spring compressor-1-.

1 -	Spring compressor -V.A.G 1752/1-

2 -	Spring retainer -V.A.G 1752/3A-

WARNING

Ensure that coil spring is correctly seated in spring retainers -V.A.G 1752/3A--2-.

–	Compress coil spring until it can be removed.

Note

Use a spanner or a reversible ratchet handle to compress spring compressor.

Installing

Install in reverse order of removal, observing the following:

–	Check that the lower spring plate is not damaged.

–	If necessary, renew lower spring plate.

–	Place lower plate onto bottom of coil spring.

Removing and installing spring, torsion beam axle

End of spring -arrow- must lie against stop on bottom spring seat.

–	Mount spring together with spring plate.

–	The bottom spring seat has a pin.

–	Insert this pin into hole in torsion beam axle.

–	Insert upper spring seat into upper end of spring.

Removing and installing spring, torsion beam axle

–	Bead of spring seat -arrow- must lie against coil spring correctly.

–	Release tension on coil spring while locating upper spring seat on lug on body.

–	Remove spring compressor.

Removing and installing spring, torsion beam axle

–	Push in clip -1- in opposite -direction of arrow- onto stop.

Specified torques

→ Chapter „Torque settings for wheel bolts“

Removing and installing spring, torsion beam axle

Repairing shock absorber

1 - Shock absorber Removing and installing → Chapter Defective shock absorbers must always be degassed and drained before ...

Removing and installing spring, multi-link suspension, left spring for front-wheel drive, left and right spring for four-wheel drive

Special tools and workshop equipment required Spring compressor -V.A.G 1752/1- &nb ...

Other materials:

Balancing wheel, balancing wheel with finish balancer
Note Before working with a finish balancer, the mechanic needs to have been instructed by the manufacturer of the balancer. To balance the wheels, set the wheels of the driven axle on the sensor platforms. On front-w ...

Removing and installing camshaft control valve 1 -N205- and exhaust camshaft control valve 1 -N318-
Note On engines with codes CMBA, CPVA, CXSA, CZCA and CPVB, only camshaft control valve 1 -N205- is installed. Removing Inlet camshaft control valve 1 -N205- – Disconnect ele ...

Warning lamp
First read and observe the introductory information and safety warnings Display Possible cause Solution The tailgate is open or not properly closed. Do not drive on! Open the tailgate and then close it again. Sev ...