Volkswagen Golf Service & Repair Manual: Removing and installing speed sensors on front axle -G45-/-G47-

Volkswagen Golf Service & Repair Manual / Brake system (hybrid) / ABS, ADR, TCS, EDL, ESP / Sensors / Removing and installing speed sensors on front axle -G45-/-G47-

Note

Removal and installation is described for the front left speed sensor. Removal and installation of the front right speed sensor is analogous.

Removing

–	Raise vehicle.

–	Release and disconnect connector -3- from front left speed sensor -G47--1-.

–	Unscrew bolt -2-, and pull front left speed sensor -G47--1- out of wheel bearing housing.

Installing

Install in reverse order of removal, observing the following:

–	Before inserting speed sensor, clean inner surface of hole, and coat speed sensor all-round with high-temperature paste -G 052 112 A3-.

Specified torque

→ Chapter „Assembly overview - speed sensor on front axle“

Removing and installing speed sensors on front axle -G45-/-G47-

Assembly overview - speed sensor on rear axle

1 - ABS speed sensor Before inserting sensor, clean inner surface of fitting hole and coat it with high-temperature paste -G 052 112 A3-. ...

Removing and installing speed sensor on rear axle -G44-/-G46-

Note Removal and installation is described for the rear left speed sensor. Removal and installation of the rear right speed sensor is analogous. ...

Other materials:

Removing and installing fuel delivery unit/fuel gauge sender, vehicles with front-wheel drive
Special tools and workshop equipment required Wrench -T10202- Torque wrench -V.A.G 1332- ...

Removing and installing front air distribution flap actuation unit, Climatronic, RHD vehicles
Removing – Remove dash panel central tube → General body repairs, interior; Rep. gr.70. – Remove air duct for defroster vent → Chapter. –&nb ...

Safety precautions when working on ignition system
Risk of injury due to electric shock The ignition system is under high-voltage when the engine is running. Touching the ignition system may result in an electric shock. – Do not touch or disconnect ignition cables when the engine is running or bei ...