Volkswagen Golf Service & Repair Manual: Removing and installing speed sensors on front axle -G45-/-G47
Note
Removal and installation is described for the front left
speed sensor. Removal and installation of the front right speed
sensor is analogous. |
|
|
|
– |
Disconnect connector -3- from
front left speed sensor -G47--1-. |
– |
Unscrew bolt -2-, and pull
front left speed sensor -G47--1-
out of wheel bearing housing. |
Install in reverse order of removal, observing the
following: |
– |
Clean inside surface of hole before inserting speed sensor. |
– |
Coat speed sensor all-round with high-temperature paste
G 052 112 A3. |
→ Chapter „Assembly overview - speed sensor on front axle“ |
|
|
|
The lateral acceleration sender -G200-, the yaw rate sender
-G202- and the longitudinal acceleration sender -G251- are
installed together with the control unit for el ...
Note
Removal and installation is described for the rear left
speed sensor. Removal and installation of the rear right speed
sensor is analogous.
...
Other materials:
Vehicle-specific weight ratings
First read and observe the introductory information
and safety warnings All data in the official vehicle documents take precedence
over these data. All data in this manual apply to the basic German model. The vehicle
data sticker in the service schedule and the official vehicle documents sho ...
Layout - infotainment system, standard display version
Display unit for control device of front display and
information control panel -J685-
Features of infotainment system standard display
5-inch monochrome touch screen
Support for ...
Bleeding fuel line to metering pump -V54- (filling with fuel)
Note
Air/fuel vapour in the fuel supply to the auxiliary heater
can lead to malfunction when the auxiliary heater is in the
sparking mode. To prevent air/fuel vapour from being drawn in by
the metering pump -V54- and conveyed to the auxili ...
© 2016-2024 Copyright www.vwgolf.org