Volkswagen Golf Service & Repair Manual: Removing and installing speed sensor on rear axle -G44-/-G46-, vehicles with
front-wheel drive
Note
Removal and installation is described for the rear left
speed sensor. Removal and installation of the rear right speed
sensor is analogous. |
|
|
|
Rear left speed sensor -G46--1-: |
|
|
|
– |
Disconnect connector -2- from
rear left speed sensor -G46-. |
– |
Unscrew bolt -1- and pull speed
sensor out of wheel bearing housing. |
Install in reverse order of removal, observing the
following: |
– |
Clean inside surface of hole before inserting speed sensor. |
– |
Coat speed sensor all-round with high-temperature paste
G 052 112 A3. |
→ Chapter „Assembly overview - speed sensor on rear axle,
front-wheel drive“ |
|
|
|
Note
Removal and installation is described for the front left
speed sensor. Removal and installation of the front right speed
sensor is analogous.
...
Note
Removal and installation is described for the rear left
speed sensor. Removal and installation of the rear right speed
sensor is analogous.
...
Other materials:
Information on wheel rims
Structure of wheel rim
1 -
Wheel rim flange
Stop for tyre side beading
2 -
Hump (H2) on both shoulders of rim
Prevents the tyre slipping off the shoulder of the rim while driving
through tight b ...
Removing and installing underbody covers – petrol/diesel
Note
The removal and installation procedures may have to be modified
slightly depending on engine fitted.
Removing
–
Remove centre underbody panels
→ Chapter.
–
Release retaining tab and pull out front co ...
Stripped profile
Tyres with stripped profile
Such damage usually develops over a longer period of time.
If an already damaged tyre is exposed to high stress, the
centrifugal forces which occur at high speeds can tear
components off the tyre.
...
© 2016-2024 Copyright www.vwgolf.org