Volkswagen Golf Service & Repair Manual: Removing and installing speed sensor on rear axle -G44-/-G46-
Note
Removal and installation is described for the rear left
speed sensor. Removal and installation of the rear right speed
sensor is analogous. |
|
|
|
Rear left speed sensor -G46--1-. |
|
|
|
– |
Disconnect connector -2- from
rear left speed sensor -G46-. |
– |
Unscrew bolt -1- and pull speed
sensor out of wheel bearing housing. |
Install in reverse order of removal, observing the
following: |
– |
Before inserting speed sensor, clean inner surface of hole,
and coat speed sensor all over with high-temperature paste
G 052 112 A3. |
→ Chapter „Assembly overview - speed sensor on rear axle“ |
|
|
|
Note
Removal and installation is described for the front left
speed sensor. Removal and installation of the front right speed
sensor is analogous.
...
The lateral acceleration sender -G200-, the yaw rate sender
-G202- and the longitudinal acceleration sender -G251- are
installed together with the control unit for el ...
Other materials:
Information stickers and plates
First read and observe the introductory information
and safety warnings Safety certificates, stickers and plates showing important
vehicle operation information are factory-fitted in the engine compartment and on
certain parts such as the tank flap, front passenger sun visor, the driver door ...
Removing and installing bracket for washer fluid reservoir,
»R«
Removing
–
Remove washer fluid reservoir
→ Chapter.
–
Remove nuts -2-.
–
Remove bracket -1- from vehicle
...
Removing and installing lower part of sump
Special tools and workshop equipment
required
Flat scraper
Commercially available scraper
Sealant remover
Hand drill with plastic brush attachment
...
© 2016-2024 Copyright www.vwgolf.org