Volkswagen Golf Service & Repair Manual: Removing and installing sill panel moulding, 4-door model
Note
Removal and installation are described for the left vehicle
side. Follow same instructions for the right side as
appropriate. |
Special tools and workshop equipment
required |
|
|
|
|
|
Wedges -T10383 |
– |
Remove rear bench seat
→ Chapter. |
– |
Remove spreader clip -1-. |
– |
Release locking lugs of sill panel moulding
-2- from lower B-pillar trim
-3--arrow A- using wedge -T10383-. |
|
|
|
– |
Release sill panel moulding -1-
from side member and beading of door seal
-arrows- using wedge -T10383-. |
– |
At the same time, pull off sill panel moulding
-1- slightly towards front. |
– |
Open cover for belt guide and thread out seat belt. |
– |
Remove sill panel moulding. |
Note
-
|
Before installing, check all fasteners for damage and
renew if necessary. |
-
|
Remove any retaining clips left in body mountings
using removal tool -T40280- and fit them in sill panel
moulding for installation. |
-
|
Following installation, ensure that the sill panel
moulding is positioned in the door seal beading. |
Installation is carried out in reverse order. |
|
|
|
Note
Removal and installation are described for the left
vehicle side. Follow same instructions for the right side as
appropriate.
...
Note
Removal and installation are described for the left
vehicle side. Follow same instructions for the right side as
appropriate.
...
Other materials:
Repair instructions
Contact corrosion
Contact corrosion can occur if unsuitable fastening elements
(screws, bolts, nuts, washers) are used.
For this reason, only connecting elements with a special
surface coating have been fitted.
In addit ...
Removing and installing intermediate padding, backrest with through-loading
aperture
Removing
–
Fold down lid for through-loading aperture.
–
Release locking lugs -1- using
a screwdriver and at the same time push down intermediate
padding -2- as far as stop
-arrow A-.
...
Connector pin assignment for auxiliary heater
1 -
6-pin connector
Information on pin assignment can be found in the latest current
flow diagram → Current flow
diagrams, Electrical fault finding and Fitting locations.
2 -
2-pin connector
In ...
© 2016-2024 Copyright www.vwgolf.org