VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing side padding

Special tools and workshop equipment required
   
  Torque wrench -V.A.G 1410-
Removing
Vehicles with side airbag
  WARNING
Observe general safety regulations when working on airbag, belt tensioner and battery isolator units (pyrotechnic components) → Chapter.
–  Disconnect battery → Electrical system; Rep. gr.27.
 

Torque wrench -V.A.G 1410

Continued for all vehicles
–  Remove bench seat → Chapter.

Removing and installing side padding

–  Unscrew nut -1-.
–  Fold down rear seat backrest.
–  Detach retaining lug -3- from body.
–  Pull side padding with retaining brackets -2- and -4- upwards.
Vehicles with side airbag
–  Disconnect wire for side airbag on side padding.
 
Installing
Install in reverse order, but note the following:
Vehicles with side airbag
–  Switch on ignition.
  WARNING
Ensure that nobody is in vehicle.
–  Connect vehicle battery → Electrical system; Rep. gr.27.
  Note
If airbag warning lamp -K75- indicates a fault following installation, event memory must be read, deleted and then read again → Vehicle diagnostic tester.
Specified torques
  → Chapter „Assembly overview - side padding“
   
Removing and installing head restraint guide
  Note 2 commercially available screwdrivers with a blade height of 0.4 mm and a blade width of 8 mm are required for removal.   ...

Separating and connecting Bowden cable for remote release mechanism for seat backrest
  Note The separating and connecting procedures are described for the left side of the vehicle. The separating and connecting procedures on the right sid ...

Other materials:

Overview of fitting locations – controls in rear doors
1 -  Rear driver side window regulator button -E711- Removing and installing → Chapter 2 -  Rear passenger side window regulator button -E713- Removing and installing → Chapter ...

Checking metering pump -V54- with end sealing valve
–  If you are uncertain as to whether the metering pump -V54--C- has an end sealing valve or not, connect e.g. hand vacuum pump -VAS 6213- to connection -A-. –  Use hand-operated vacuum pump to a generate a vacuum of ...

Introduction
This chapter contains information on the following subjects:  → Technical requirements    → Mechanically positioned ball coupling    → Fitting a bicycle carrier on the mechanically positioned ball coupling    → Hitching and connecting the trailer     ...

© 2016-2024 Copyright www.vwgolf.org