Volkswagen Golf Service & Repair Manual: Removing and installing side defroster vent

Volkswagen Golf Service & Repair Manual / General body repairs, interior / Trim, noise insulation / Dash panel / Removing and installing side defroster vent

Note

Removal and installation is described for the side defroster vent on driver side. Follow same instructions for the front passenger side as appropriate.

Special tools and workshop equipment required

Removal wedge -3409

Removing

–	Lever defroster vent -1- upwards out of assembly aperture in dash panel using removal wedge -3409- and remove it.

Installing

Installation is carried out in reverse order.

Removing and installing side defroster vent

Removing and installing dash panel vents

Special tools and workshop equipment required Front-end hook -3370 ...

Dash panel central tube

...

Other materials:

Checking valve timing, engine codes CHPA, CMBA, CPVA, CXSA, CZCA, CPVB, CZDA
Special tools and workshop equipment required Torque wrench -VAS 6583- Locking pin -T10340- ...

Checking fuel delivery rate
Special tools and workshop equipment required Removal wedge -3409- Remote control for V.A.G. 1348 -V.A.G 1348/3A- Multimeter e.g. hand-held multimeter -V.A.G 1526E- Test instrument adapter/DSO (5-pin) -VAS 5565- ...

After purging refrigerant circuit of contaminants, e.g. due to moisture intrusion (because refrigerant circuit has stood open for a length of time) or due to dirt
The reservoir or receiver or cartridge of the dryer bag need not be renewed under the following circumstances: After an accident in which there was no damage to the reservoir or receiver. Repairs are performe ...