Volkswagen Golf Service & Repair Manual: Removing and installing selector lever position display -Y26-
Note
The selector lever position display -Y26--1-
is integrated in the selector lever gaiter and cannot be removed
individually. |
|
|
|
The removal and installation procedures are described for
LHD vehicles. Removal and installation for RHD vehicles are
similar. |
– |
Removing selector level gaiter
→ Rep. gr.34. |
Installation is carried out in the reverse sequence. |
|
|
|
Note
Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way (mirror image ...
Removing
Caution
Danger of damage to component surfaces.
When using levera ...
Other materials:
Adjusting the steering wheel position
Fig. 50 Adjusting the steering wheel position
mechanically
First read and observe the introductory information
and safety warnings Adjust the steering wheel position before setting off
and only when the vehicle is stationary.
Push down the lever .
Adjust the steering wheel s ...
Renewing bonded rubber bush for wheel bearing housing, front-wheel drive
Special tools and workshop equipment required
Assembly tool -3301-
Assembly tool -3346-
Assembly tool -3350-
Assembly tool -T10356-
Carrier -3390-
Torque wrench -V.A.G 1332-
&nb ...
Removing and installing coolant pipes
Special tools and workshop equipment
required
Hose clamps up to 25 mm -3094-
Hose clip pliers -VAS 6362-
...
© 2016-2024 Copyright www.vwgolf.org