Volkswagen Golf Service & Repair Manual: Removing and installing seat adjustment operating unit -E470-/-E471-

Volkswagen Golf Service & Repair Manual / General body repairs, interior / Seat frames / Front seats / Removing and installing seat adjustment operating unit -E470-/-E471-

Note

Removal and installation are described for the left vehicle side. Follow same instructions for the right side as appropriate.

Special tools and workshop equipment required

Release tool -T10236-

Removing

–	Remove seat trim on sill side → Chapter.

–	Carefully lever buttons -3- and -4- out of catches on seat adjustment operating unit using release tool -T10236-.

–	Remove bolts -2-.

–	Remove seat adjustment operating unit -1-.

Installing

Installation is carried out in reverse order.

Specified torques

Removing and installing seat adjustment operating unit -E470-/-E471-

Component	Specified torque
Bolt -1-	1 Nm

Removing and installing lumbar support adjustment motor -V125-/-V126-/-V129-/-V130-

Special tools and workshop equipment required Special pop rivet pliers -V.A.G 1753B- ...

Removing and installing massage control unit -J740-

Special tools and workshop equipment required Removal wedge -3409 ...

Other materials:

Removing and installing brake caliper PC57
Special tools and workshop equipment required Removal wedge -3409- Piston resetting appliance -T10145- Re ...

Releasing gas and draining rear gas-filled shock absorbers, DCC shock absorbers
Clamp gas-filled shock absorber vertically in vice. WARNING Safety goggles must be worn when drilling. – Drill a 3 mm hole -A- through ...

Bleeding hydraulic system following standard procedure
Note Bleeding the hydraulic system using brake filling and bleeding equipment -VAS 5234- is described. A pre-pressure of 2 bar is required for bleeding the ABS hydraulic unit -N55-. Specia ...