Volkswagen Golf Service & Repair Manual: Removing and installing Sanden belt pulley
 Note
| The pulley is sensitive to impact and should therefore be
treated with extreme care. |
| If the belt pulley overload protection has deployed, check
freedom of movement of air conditioner compressor before
renewing belt pulley. If air conditioner compressor cannot
rotate freely it must be renewed. |
| If the drive plate overload protection device has been
triggered, the pulley can rotate with the outer section of the
drive plate without the air conditioner compressor shaft and the
hexagon flats attached to the drive plate (inner section of
drive plate) also rotating. |
| – |
Remove poly V-belt
→ Rep. gr.13. |
| – |
Removing and installing belt pulley
→ Chapter. |
|
|
|
Note
The pulley is sensitive to impact and should therefore be
treated with extreme care.
If the belt pulley overload prot ...
Other materials:
Removing and installing emblem with model designation, “R”
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
Note
Only remove when radiator grille -3- is
removed.
Removing
...
2-pack epoxy primer surfacer
Designation:
2-pack epoxy primer surfacer -LLS MAX 220 M1-, beige
(250 ml)
2-pack epoxy primer surfacer -LLS MAX 220 M2-, beige
(400 ml)
Issued 03.2013
...
Matching wheel rims and tyres
If necessary, eliminate flat spots caused by storage or
handling
→ Chapter.
–
Press tyre off wheel rim
→ Chapter.
–
Rotate tyre by 180° relative to wheel rim.
...
© 2016-2024 Copyright www.vwgolf.org
Removing and installing Denso belt pulley
Control motors