Volkswagen Golf Service & Repair Manual: Removing and installing right vent temperature sender -G151

Volkswagen Golf Service & Repair Manual / Heating, air conditioning / Air conditioner / Other controlling and regulating components / Removing and installing right vent temperature sender -G151

Special tools and workshop equipment required

Vehicle diagnostic tester

Removing

Note

Only on vehicles with Climatronic. On vehicles with heater or air conditioning system with electric/manual controls, the apertures in the air ducts are sealed with plugs.

The illustration shows a left-hand drive vehicle. The procedure is identical.

–	Remove dash panel end cover → General body repairs, interior; Rep. gr.70.

–	Turn vent temperature sender -1- in -direction of arrow- and pull it out of mounting.

–	Disconnect electrical connector -2-.

Installing

Installation is carried out in the reverse order. When installing, note the following:

Removing and installing right vent temperature sender -G151

–	Renew seal -3- if damaged or defective.

Note

An incorrectly installed vent temperature sender will cause flow noise.

–	As a final step, read event memory, and erase any entries displayed using vehicle diagnostic tester in “Guided fault finding” mode.

Specified torque

Dash panel; Removing and installing dash panel end cover → General body repairs, interior; Rep. gr.70

Removing and installing right vent temperature sender -G151

Removing and installing left vent temperature sender -G150

Special tools and workshop equipment required Vehicle diagnostic tester Removing Note ...

Removing and installing footwell vent temperature sender -G192

Special tools and workshop equipment required Removal wedge -3409- Vehicle ...

Other materials:

Removing and installing easy-entry Bowden cable A
Removing – Remove front seat → Chapter. – Secure front seat on seat repair stand → Chapter. – Move front seat to highest position. ...

Assembly overview - belt pulley, Denso air conditioner compressor
1 - Bolt Qty. 3. 4.5 Nm 2 - Sealing cap 3 - Nut 25 Nm – To unfasten and tighten the hexagon nut, hold the pulley in position with ...

Overview of fitting locations - auxiliary heater components, Golf and Golf GTE
Note The illustration shows a Golf. 1 - Auxiliary heater aerial -R182- For vehicles with auxiliary heater and remote control. Removing and installing auxiliary h ...