Volkswagen Golf Service & Repair Manual: Removing and installing right temperature flap control motor -V159-, RHD vehicles

Volkswagen Golf Service & Repair Manual / Heating, air conditioning / Air conditioner / Control motors / Removing and installing right temperature flap control motor -V159-, RHD vehicles

Special tools and workshop equipment required

Vehicle diagnostic tester

Bit ratchet

First carry out the following work:

–	Switch off all electrical consumers.

–	Switch off ignition.

–	Remove ignition key.

Removing

Note

Evaporator temperature sensor -V159- is accessible from footwell.

The illustration shows a left-hand drive vehicle. However, the procedure is analogous.

The bolts can be accessed with a small commercially available bit ratchet.

Pyrotechnic components may trigger unintentionally.Risk of injury.Discharge any static charge accumulated in your body by briefly touching striker plate for door.

–	Pull off actuating lever -1- for temperature flap.

–	Unscrew bolts -arrows-.

–	Remove right temperature flap control motor -V159--2-.

–	Disconnect electrical connector -3-.

Removing and installing right temperature flap control motor -V159-, RHD vehicles

Installing

Installation is carried out in the reverse order. When installing, note the following:

Note

Check operation of flaps and hinge mechanism before fitting.

Make sure levers and shafts are properly fitted in the mounts.

–	Position control motor -1- on air distribution housing. Gear wheel -3- of control motor must engage in gear wheel -1- of temperature flap lever.

The long tooth -4- must engage in recess -arrow- on actuating lever.

Note

If the gear wheels on the control motor and temperature flap lever do not align, rotate the receptacle in the control motor.

If the bolts cannot be fitted, the control motor is not completely seated on the housing.

–	Switch on ignition, connect respective control motor to vehicle wiring harness and select a setting on operating and display unit to set control motor to desired position (e.g. mid-position). Wait until control motor has moved to desired position and switch off ignition.

–	Route wiring harness so that it cannot come into contact with any moving parts (e.g. actuating arm on control motor).

Note

Rotate control motor until it reaches a convenient position for installation. The direction of rotation can be changed by changing polarities.

–	Read event memory, and clear any entries displayed. Then, perform “basic setting”vehicle diagnostic tester in “Guided fault finding” mode.

–	As a final step, check operation of heater and air conditioning system.

Specified torque

→ Chapter „Assembly overview - heater and air conditioning unit“

Removing and installing right temperature flap control motor -V159-, RHD vehicles

Removing and installing right temperature flap control motor -V159-, LHD vehicles

Special tools and workshop equipment required Vehicle diagnostic tester First carry out the following work: ...

Removing and installing fresh air/recirculated air, air flow flap control motor -V425-, LHD vehicles

Special tools and workshop equipment required Vehicle diagnostic tester First carry out the following work: ...

Other materials:

Removing and installing damper element for glove compartment lid
Removing – Move glove compartment lid to service position → Chapter. – Disconnect connector for glove compartment light switch -E26- on damper element -1-. – ...

Introduction
This chapter contains information on the following subjects: → Function and operation by the user The Driver Alert System informs the driver if his or her driving shows signs of tiredness. Additional information and warnings: Infotainment system Accessories, modifica ...

Removing and installing glove compartment cover
Removing – Remove glove compartment → Chapter. – Place glove compartment on a soft surface. – Move glove compartment lid to service position U ...