Volkswagen Golf Service & Repair Manual: Removing and installing retainer for digital sound package control unit -J525-

Volkswagen Golf Service & Repair Manual / Communication / Infotainment / Sound system / Removing and installing retainer for digital sound package control unit -J525-

Special tools and workshop equipment required

Torque wrench -V.A.G 1783-

Removing

–	Removing digital sound package control unit -J525- → Chapter.

Removing and installing retainer for digital sound package control unit -J525-

–	Fold back floor covering and floor insulation from middle tunnel and floor panel.

–	Unscrew bolt -1- from middle tunnel and nuts -2- from retainer.

–	Remove retainer from digital sound package control unit -J525--3-.

Installing

Install in the reverse order of removal. When doing this, note the following:

Removing and installing retainer for digital sound package control unit -J525-

Specified torques

Component	Specified torque
Bolt -1-	6 Nm
Nuts -2-	6 Nm

Removing and installing digital sound package control unit -J525

Special tools and workshop equipment required Protective cap for wiring harness connector -VAS 6223/9- ...

Removing and installing front treble loudspeakers -R20-/-R22-

Front left treble loudspeakers -R20-/front right treble loudspeakers -R22- are located in A-pillar trim. Note If the treble loud ...

Other materials:

Removing and installing headlight washer system pump -V11-, »R«
Special tools and workshop equipment required Drip tray Removing – Remove washer fluid reservoir → Chapter. ...

Identification plates
There are different types of identification plates. When the auxiliary heater is replaced, check the type plate and the duplicate plate and replace as necessary. Identification plate on ...

Removing and installing air recirculation flap control motor -V113-, LHD vehicles
Heater and air conditioning system with electric/manual controls Special tools and workshop equipment required Vehicle diagnostic tester Note The control motor has end stops wi ...