Volkswagen Golf Service & Repair Manual: Removing and installing remote control receiver for auxiliary coolant heater
-R149-, Golf Variant
Note
If the remote control receiver for auxiliary coolant heater
-R149- is renewed, the remote control receiver for auxiliary
coolant heater -R149- needs to be adapted to the auxiliary and
supplementary heater using the vehicle diagnostic tester in
“Guided fault finding” mode. |
Special tools and workshop equipment
required |
|
|
|
– |
Remove luggage compartment side trim on right
→ General body repairs, interior; Rep. gr.70. |
|
|
|
– |
Remove bolts -2- from bracket
-1- for Telestart. |
– |
Remove bracket for Telestart far enough that remote control
receiver for auxiliary coolant heater -R149- is accessible. |
|
|
|
– |
Separate connectors -3- and
-4-. |
– |
Press securing tab aside using removal wedge -3409-. |
– |
Pull remote control receiver for auxiliary coolant heater
-R149--2- upwards off bracket for
Telestart. |
Install in reverse order. |
Note
If the remote control receiver for auxiliary coolant heater
-R149- is renewed, the remote control receiver for auxiliary
coolant heater -R149- needs to be adapted to the auxiliary and
supplementary heater using the vehicle diagnostic tester in
“Guided fault finding” mode. |
|
|
|
Component |
Specified torque |
Bolts on bracket
for Telestart |
2 Nm |
Install luggage compartment side trim on right
→ General body repairs, interior; Rep. gr.70. |
|
Note
If the remote control receiver for auxiliary coolant heater
-R149- is renewed, the remote control receiver for auxiliary
coolant heater -R149- nee ...
Note
The auxiliary and supplementary heater can be switched on
and off from a distance of several 100 metres (open space) using
the remote c ...
Other materials:
Vehicles with multilink suspension
The connecting pipe can be cut through at the cutting point
in order to renew the centre and rear silencers separately.
Cutting point is marked by an indentation on circumference
of exhaust pipe.
Special tools and ...
Repairing threaded connections
Special tools and workshop equipment
required
VAG 1331
Note
The use of penetrating fluid, contact spray or grease etc.
is prohibited since the missing ad ...
Balancing wheel, conditions
Before you start balancing the wheels, the following
requirements must be met.
Tyre pressure must be OK.
Tread must not be worn on one side. Tread depth should be at
least 4 mm.
T ...
© 2016-2024 Copyright www.vwgolf.org