Volkswagen Golf Service & Repair Manual: Removing and installing refrigerant line between condenser and evaporator

Volkswagen Golf Service & Repair Manual / Heating, air conditioning / Air conditioner / Refrigerant circuit / Removing and installing refrigerant line between condenser and evaporator

Special tools and workshop equipment required

Engine bung set -VAS 6122

Torque wrench -V.A.G 1331/- (5…50 Nm)

Air conditioner service station

Removing

–	Observe safety precautions → Chapter „Safety precautions when handling refrigerants“.

–	Comply with notes → Chapter „Working on refrigerant circuit“.

–	Extract refrigerant using air conditioner service station before opening refrigerant circuit.

–	Remove front bumper cover → General body repairs, exterior; Rep. gr.63.

–	Remove right engine mounting → Rep. gr.10.

Risk of freezing injury caused by escaping pressurised refrigerant.There is a risk of injury to the skin and parts of the body due to freezing.Always wear safety gloves.Always wear safety goggles.Extract refrigerant, and open the refrigerant circuit immediately afterwards.If more than 10 minutes passed since the refrigerant has been extracted, do not open the refrigerant circuit prior to extracting refrigerant anew. Due to re-evaporation, pressure will be built up in the refrigerant circuit.

Removing and installing refrigerant line between condenser and evaporator

–	Unscrew nut -1-.

–	Separate refrigerant lines.

Removing and installing refrigerant line between condenser and evaporator

–	Unscrew bolt -5- of lower refrigerant line -3-.

–	Remove refrigerant line -3- from condenser -1-.

–	Unclip refrigerant line -3- from retainers, and remove it.

Installing

Installation is carried out in the reverse order. When installing, note the following:

–	Renew seals. For versions, refer to → Electronic Parts Catalogue.

–	Moisten seals with refrigerant oil before installing → Chapter.

Note

Ensure proper seating of seals in the groove of the respective refrigerant line.

Specified torques

→ Chapter „System overview - refrigerant circuit“.

Assembly overview - assembly mountings → Rep. gr.10

Front bumper cover → General body repairs, exterior; Rep. gr.63

Removing and installing refrigerant line between condenser and evaporator

Refrigerant line with restrictor

Observe safety precautions → Chapter „Safety precautions when handling refrigerants“. – Comply with notes →& ...

Removing and installing refrigerant line between condenser and air conditioner compressor

Special tools and workshop equipment required Torque wr ...

Other materials:

Introduction
This chapter contains information on the following subjects: → Displays → Description ProActive occupant protection is an assistance system that initiates action to protect vehicle occupants in dangerous situations. However, the system cannot prevent a collision. Add ...

Tools and materials commercially available
Caution Non-authorised tools or materials (e.g. leak inhibitor additive) may cause damage or adversely influence the system. Only tools and materials a ...

Removing and installing defroster flap control motor -V107- with potentiometer -G135-, RHD vehicles
Special tools and workshop equipment required Vehicle diagnostic tester First carry out the following work: – Switch off all electrical consumers. – ...