VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing rear side airbag with rear side airbag igniter -N201-/-N202-

Volkswagen Golf Service & Repair Manual / General body repairs, interior / Pasanger protection / Side airbags / Removing and installing rear side airbag with rear side airbag igniter -N201-/-N202-

Removing
  WARNING
  Observe safety instructions for pyrotechnic components → Chapter.
  Observe the additional safety regulations for the side airbag → Chapter.
  Observe disposal regulations for pyrotechnic components → Chapter.
   
–  For “e-Golfs” or “Golf GTEs”, disconnect the maintenance connector for high-voltage system -TW-.
–  Disconnect battery earth cable with ignition switched on → Electrical system; Rep. gr.27.
–  Remove side padding  → Chapter.
 

Removing and installing rear side airbag with rear side airbag igniter -N201-/-N202-

–  Remove the 2 bolts -2-.
–  Unclip connector -1- from seat bolster.
–  Remove side airbag -3- from airbag pocket -4-.
Installing
–  Install in reverse order of removal.
–  Switch on ignition.
  WARNING
Ensure that nobody is in vehicle.
 

Removing and installing rear side airbag with rear side airbag igniter -N201-/-N202-

–  For “e-Golfs” or “Golf GTEs”, connect the maintenance connector for high-voltage system -TW-.
–  Connect vehicle battery → Electrical system; Rep. gr.27.
  WARNING
If the ignition has not yet been switched on after the battery has been reconnected “warning lamps in dash panel insert are off”, the ignition (key or button) must only be switched on while sitting on the driver seat and with the seat set to rearmost position.
Specified torques
  → Chapter „Assembly overview - rear side airbag“
 

Removing and installing rear side airbag with rear side airbag igniter -N201-/-N202-

Removing and installing front side airbag with side airbag igniter -N199-/-N200-
Removing   WARNING   Observe safety instructions for pyrotechnic components U ...

Curtain airbags
...

Other materials:

Assembly overview - door components
  Note Only the left side is shown. The right side is similar. 1 -  Front door Removing and installing → Chapter Adjusting → Chapter 2 -  Sticker Diameter 28 mm If necessary, manu ...

Removing and installing glow plug with flame monitoring -Q8
Removing –  Dismantling and assembling auxiliary heater → Chapter.     –  Pull out retaining spring -1- in direction of -arrow-. ...

Removing and installing heat shield for rear silencer
Special tools and workshop equipment required         Engine and gearbox jack -VAS 6931-   Note The removal and installation procedures may have to be modified slightly ...

© 2016-2024 Copyright www.vwgolf.org